Turborevs 70mm (2.75") Heavy Duty Stainless Steel Exhaust Sleeve Connector Pipe & Clamp

Got a rusty or leaking section in your exhaust?

Before you go replacing the whole system, check out this heavy-duty repair solution from Turborevs.

It's a 70mm (which is about 2.75 inches) stainless steel exhaust sleeve connector.

Basically, it's a pipe that slides over your existing exhaust pipes to bridge a gap or cover a hole, and it comes with the clamps to secure it tightly.

It's a super common fix for joining two pipes or repairing a damaged section.

Made from heavy-duty stainless steel, it's going to resist rust way better than the original mild steel, so this repair should last a long time.

The manufacturer part number is EP70.

It's a brand new part, ready to bolt on.

Whether you're a home mechanic or a pro, this is an easy, effective way to seal up your exhaust and get your ride sounding quiet again.

Just slide it on, tighten the clamps, and you're done.

No welding required!