SPP 1-Inch Open Center Carburetor Spacer (Square Bore) For Holley/Edelbrock - Aluminum, Includes Hardware, SPT5932/2103
About this item
Hey hot rodders and engine builders.
If you're working on a carbureted engine, this spacer might help.
It's from SPP, part numbers 2103 and SPT5932.
It's a 1-inch tall, open center carburetor spacer.
It's designed for square bore carbs like Holley and Edelbrock on a square bore intake manifold.
It's made of aluminum, which is light and dissipates heat well.
The open center design helps with airflow and can increase plenum volume for more power.
It comes with all the mounting hardware you need, so it's ready to bolt on.
It's a regular size, 1 inch thick.
The surface finish is raw aluminum.
It's a simple way to fine-tune your intake setup.
It can help with fuel atomization and throttle response.
It's a common upgrade on V8s.
So if you need to raise your carb a bit for hood clearance or want to experiment with intake tuning, grab this spacer.
It's a good quality piece from SPP.
Easy to install.
Just bolt it between your manifold and carb.
It's a cheap and easy mod.
Get it and see if it wakes up your engine.
Good stuff.- Free shipping
- Free 30-day returns
How do you want your item?
Free 30-day returns
