Eaton 10250T3 Contact Block 2NC 10A 600V - New Open Box Surplus

This is a new open-box Eaton 10250T3 contact block, part of the NSB series.

It’s an unused surplus item, still in the original box, though the box might show a little shelf wear.

The block itself is clean and ready to use.

It features a 2NC (normally closed) contact configuration, rated for 10 amps at 600 volts.

The size is 30.5mm, standard for industrial controls.

It weighs about 0.8 pounds.

These are commonly used with push buttons, selector switches, and other pilot devices.

Since it’s open box, it doesn’t carry a manufacturer’s warranty, but it’s fully tested and functional.

If you’re building a control panel or replacing a worn-out block, this is a solid, cost-effective choice.

Eaton makes reliable gear, and this one is no different.

Just wire it up and it’s good to go.